Maine Radon & Water Treatment Before & After Photos

Before:
Loretta S. in Boothbay, Maine had a water test that revealed several concerns affecting overall water quality. The analysis showed:

• Iron: 0.51 mg/L

• Manganese: 0.194 mg/L

• Hardness: 81.4 mg/L (moderately hard water)

While the water was safe in many categories, the iron and manganese levels were beginning to affect water clarity, taste, and could lead to staining over time. Loretta wanted a reliable system that would improve water quality throughout the home.

After:

We installed a 10 x 54 Evolve® Standard Water Softener with Vortech Tank and Sweat Jacket, designed to address hardness and improve overall water performance. The Vortech tank technology helps the system regenerate more efficiently while using less water.

The installation was clean and professionally configured, giving Loretta a modern water treatment system designed for consistent performance and improved water quality throughout her home.

Another Boothbay home now enjoys cleaner, better-performing water with a premium Evolve® system.

In Clinton, ME, a home tested above the recommended radon levels, which prompted the need for a mitigation system to reduce exposure risks. The homeowner turned to Maine Radon and Water Treatment for their trusted experience and reliable service. Our team carefully planned the installation, paying special attention to radiant heating lines while selecting the rear corner of the home for the system setup. An RN2 fan was installed with proper venting and a manometer to monitor system performance, ensuring the radon levels could be brought down effectively. If you’re concerned about radon in your home, reach out to Maine Radon and Water Treatment to learn how we can help protect your living space.

Before:
Lori’s home required a more thoughtful, multi-area approach due to the layout and construction. With considerations around the drainage system, sump pit, and slab conditions, it was important to design a system that could adapt if needed—especially in the elevated area where airflow beneath the slab was uncertain.

During:
We installed a sub-slab depressurization system (Zone 3), including a sealed sump lid and a radon mitigation membrane to help control vapor and improve system performance. The setup also included a 10-foot extension to properly route the system.

We planned ahead by allowing for a potential additional extraction point, depending on how the system performs. If testing shows limited airflow in that elevated section, we’re ready to adjust and optimize further.

After:
Lori now has a professionally installed, adaptable radon system designed specifically for her home’s layout. With the system in place and performance being monitored, she can move forward knowing the setup is built to handle both current conditions and any future adjustments if needed.

Not every home is the same—this one was built with flexibility in mind.
Another Maine home protected with a solution designed to perform.

Clinets we're really conserned since there initial radon air readings were 180pcil. They contacted us and trusted us in getting these results as low as possible. We then were able to core drill and hit the interior drainage tile which will allow for great communication. We installed a premium fan and sealed off all drains as well as seal cracked around the floor. We are confident this will bring levels as low as possible.

In Boothbay, ME, a homeowner reached out to Maine Radon and Water Treatment after learning their indoor radon levels tested at 7.4 pCi/L—well above the EPA action level. Concerned about long-term exposure, they wanted a reliable solution before the issue grew worse. After reviewing their options, they chose Maine Radon and Water Treatment for their expertise and trusted reputation. Our team carefully designed and installed a mitigation system, making adjustments for a drain under the furnace and routing the system through the rear corner of the home as requested. The result was an efficient system with a properly installed RN2 fan, stone, and manometer reading at 1.0, helping to significantly reduce radon levels and lower the associated risks. If you’re worried about radon in your home, contact Maine Radon and Water Treatment today to schedule your test and explore mitigation options.